База знаний
How to install and use YUM? Распечатать статью
YUM is pre-installed on your dedicated virtual server. YUM has many uses, the basis use is software installation. You can use YUM via SSH.
To install a new software type the command "yum install PKGNAME (type the software name in the place PKGNAME)" in SSH. To remove a software type the command "yum remove PKGNAME".
Помог ли вам данный ответ?
Связанные статьи
How to enable root access to dedicated virtual servers?
Root access is not enabled by default for dedicated virtual servers, but you can enable it in...
Root access is not enabled by default for dedicated virtual servers, but you can enable it in...
How to use telnet to send email?
To send emails using telnet, follow the below steps. 1. In the command prompt, use the code...
To send emails using telnet, follow the below steps. 1. In the command prompt, use the code...
How to check and read emails using telnet?
To check and read emails using telnet, follow the below steps. 1. In the command prompt, type the...
To check and read emails using telnet, follow the below steps. 1. In the command prompt, type the...
How to turn off safe mode in Plesk using SSH?
To turn off safe mode globally, follow the below steps. 1. Login to your server via SSH.2. Open...
To turn off safe mode globally, follow the below steps. 1. Login to your server via SSH.2. Open...
How to enable SSH?
In your Grid service, the SSH is disabled by default, but you can enable it using the below...
In your Grid service, the SSH is disabled by default, but you can enable it using the below...